Put a ruler under the camera and measure the box size, like this: Set the Camera UnitsĬheck the “Draw Box” tick box and adjust zoom to less than 2, so that the box fits the image.
Tighten and re-check that the alignment is good. Adjust the camera so, that the horizontal red line matches the ruler edge. Your ruler now aligns exactly to the machine X axis. Adjust the ruler so, that at both ends, the ruler edge aligns with the center cross. (Hint: At this point, you might put a needle to your table and support that point of the ruler against it.) Move the machine in left-right direction to the other end of the ruler. Put a ruler on your table, and adjust the position or jog the machine so, that at the center of the image, a point on the edge of the ruler aligns with the cross. Select the “Draw Cross” tick box on the right of the image this draws the red alignment cross on the image.
Here Is an example of bad and an on OK light setup: It is not overly critical, but you still want good, even light to your system. Turn these down.Īdjust the shades so, that you get evenly diffused light on your image. the intensity control for the built-in lights is in the USB connector. The cameras have built-in lights, that normally do more harm than good. Make yourself familiar with this function, it will be helpful in adjustments: ZoomĪt the lower right of the program screen, there is a selection box for camera zoom on/off and for the zoom factor. Adjust the camera to approximately in right orientation. Loosen the camera attachment screw so, that you can turn the camera, but the camera does not fall. Note, that installing any software is not required, although there is a disc inside the camera boxes. If you have troubles connecting to the cameras or switching between them, please see troubleshooting section at the end of the next page. Now is also a good point to check that you can get an image from both cameras. Select one of the generic USB cameras, until you get the image of the down looking camera to appear. If no cameras appear, check your connections. The leftmost selection box lists your cameras. To the right of the image box, notice the camera selection section: Select the Setup Cameras tab on the program.
0 kommentar(er)
